How to install solar street lights correctly?

In recent years, with the deterioration of the Earth's environment, solar energy resources have been increasingly valued. Therefore, countries have increased the allocation of solar energy resources. Solar street lights are a branch of solar energy resource application. The products sold on the market are integrated solar street lights and split solar street lights, mainly integrated solar street lights that integrate solar panels, light sources, controllers, and batteries. One of the advantages of integrated solar street lights is that they are easy to purchase, transport, install, and maintain. When it comes to setting up, many people do not know about the knowledge and installation methods of solar street lights. So, let's learn together how to correctly install solar street lights!

Installation Manual for Solar Street Lights

（1） Site selection

1. According to the direction of the road and the position of the light source of the lamp, select the direction of the light source of the lamp, pay attention to the latitude of the installation location of the lamp, adjust the angle of the solar panel, and the tilt angle should be based on the local latitude to meet the irradiation area of the solar panel.

2. Solar street lights must be equipped with sufficient light, and the facing surface of the solar panel should not block shadows throughout the day. The solar panel faces north and south towards the hemisphere; In the southern hemisphere, facing south and north, the board can be flattened near the equator.

3. Solar street lights should not be placed near heat sources and should not affect the lifespan of the lamps.

4. Environmental operating temperature: -20~60. In colder environments, system configuration should be appropriately increased to enhance temperature protection.

5. There must be no direct light source on the solar panel. Prevent misoperation caused by misidentification of the lighting control system.

（2） Foundation

When installing the foundation underground: When the soil at the measurement location is hard, dig a hole of about 1 cubic meter at the location where the lighting fixtures are installed. Adjust according to the height of the lighting fixture. If there is soft soil or special requirements, the excavation depth will be calculated separately.

（3） Installation

1、 Inspection and testing;

1. Check if the accessories are complete,

2. Test whether the lighting fixtures are working properly.

The lamp works normally in demonstration mode and is considered to be in good condition. Tested: Please set the remote control to the mode you have set.

2、 Lamp head assembly

1. Remove the 3 screws that secure the top cover and firmly fix it.

2. Fix the bracket onto the solar panel using the 6 screws in the metal parts bag.

3. Adjust the angle of the solar panel in advance, and assemble the solar panel and lamp holder.

4. When connecting solar cell modules to brackets, they must be reliable

5. The output lines of the components should be avoided from being exposed and firmly fixed with zip ties

6. The direction of the solar panel is due south, follow the direction of the compass

be careful; The anti slip screws must be tightened.

3、 Assembly of lamp head and lamp post

1. Install the lamp head with solar panels onto the lamp post. Attention: The diameter of the lamp post is 60-70mm, which varies depending on the installation diameter of the lamp

2. Tighten the screws of the 6 locking rods.

3. Complete installation

The above introduction is about how to correctly install solar street lights. If you need to learn more, please feel free to contact us at any time!